HELP with Reef Octopus sss-3000int

globaldesigns · #1 03-06-2013, 03:48 PM

Quote:

Originally Posted by RDNanoGuy

If the water is shooting out its not set up right. Open the gate valve all the way and drop the skimmer so the output is 3/4 under the waters surface. Take off the cup. Open the air restrictor all the way then close the gate valve until the foam is just about to spill over the top of the skimmer body. Then put the cup back on. If you are getting micro bubbles escaping the reaction chamber, close the air restrictor a little bit and adjust the gate to keep the foam head at the same level.

Also let the skimmer run for an hour after each change. Skimmers don't like constant fiddling. A properly sized skimmer will not produce skimmate constantly. It will produce only when there is enough DOC's for the foam head to reach the top of the neck. After the levels of DOC's in the water column fall past a certain point the skimmate will stop flowing into the cup until the levels of DOC's rise again. If your skimmer is skimming constantly it is too small for you bioload.

Hope that helps.

This is a great help, thanks... Also thanks to everyone so far with their help.

I will try what everyone has suggested. If there is anything new to add, please feel free to let me know. Thanks again all!!!

Ryan-b · #2 03-06-2013, 10:53 PM

I have the SRO 3000-int not the sss model not sure if there is that much of a difference but for the noise I added this to the output, no noise at all now

Its just a piece of electrical pvc, its not a perfect fit but it works. I think the size of the output is metric so I had to use the closest thing I could find. as the noise was driving me crazy as well.