Separate skimmer container

[CherylMcKay]

Originally Posted by The Grizz

Can you change the 1" line going from sump to sump to a 1 1/2" to open it up some more & give the flow more breathing room? Maybe just add 1 or 2 more 1" lines. If there's is 2 - 1" lines going in there should be atleast 2 - 1" or bigger lines going out to return side.

That was my plan but I wasn't sure if I should do that or put a pump in the skimmer container with a float switch.

Another question. If I need 10 " for the skimmer, do I drill so the bottom is st 10 " or the center of the bulk head?

Sent from my Nexus 7 using Tapatalk 2

[The Grizz]

Originally Posted by CherylMcKay

That was my plan but I wasn't sure if I should do that or put a pump in the skimmer container with a float switch.

Another question. If I need 10 " for the skimmer, do I drill so the bottom is st 10 " or the center of the bulk head?

Sent from my Nexus 7 using Tapatalk 2

Make it so that you have the 10" required so pipes need to be set so they are just above the 10" mark.