Bubble in primary seal - help!

[carriej]

It's in my basement on a concrete slab. Honestly, it can't hurt anything if it explodes. Water will just go down the drain. Along with my hopes and dreams.. LOL

I'm more worried about my future livestock and corals. I would be TICKED if I wasted $1000 on living things and my tank failed... I don't care if the seam is "ugly" or what-have-you.

It has lifetime warranty but I don't want to go through that hassle if this does not effect the structure of the tank.

[mike31154]

What soapy said. I'm no tank builder either, but from the looks of it the 'bubble' is in the layer of silicone that is applied after the glass panes are actually bonded together. If not mistaken, a layer of silicone is added at all seams after the tank is assembled & smoothed out to give that 'finished' look. If that tank isn't leaking right now, I wouldn't sweat it. Clearly the quality control person was having an off day. But this is the internet after all....

[carriej]

It's in the silicone that sandwiches the two panes of glass together. I understood this as the "primary seal". I have no idea how to build a tank, but a buddy of mine does quite a bit of it. He says not to worry but man... I am not loaded and would be so disappointed to have a tank explode and lose a bunch of fish and corals.

That other bubble you see is actually in the water caused by powerhead.. We are looking at the lengthwise skinny bubble in the seam.

[Proteus]

That's why my next tank is black silicone. Can't see the bubbles

[sphelps]

It's typical, pretty hard to build a tank without some bubbles in the seam. If you only have one you're doing pretty good. That's certainly not going to cause any issues.

[lastlight]

Look around at most of the custom tanks around and I'd be amazed if any had a seal as pristine as that. You have only one bubble that's actually pretty amazing. Evey tank I've had no matter how nice they look have had plenty of bubbles. I think I was told once that as the seals cure and tighten up they can actually create those marks.

My 225 was black silicone and I worried even more lol. I could see the joint lighten in colour as I filled the tank and the pull on the seam increased.

That tank looks very well built.

[waynemah]

Originally Posted by lastlight

My 225 was black silicone and I worried even more lol. I could see the joint lighten in colour as I filled the tank and the pull on the seam increased.

Well there goes my nights sleep lol.

[lastlight]

Originally Posted by waynemah

Well there goes my nights sleep lol.

Oh ummm... this was ANOTHER 225 I had =)

Not that hard to believe I had another is it? (If it helps you haha).

[denny_CC]

youll be fine

[toytech]

lots of tanks have bubbles in the seal its no biggie , start looking at other peoples tanks and i bet you will find more.