Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Tank Journal

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 10-30-2012, 04:01 PM
mseepman mseepman is offline
Gold Member
 
Join Date: Aug 2007
Location: Vernon
Posts: 2,529
mseepman is on a distinguished road
Default

The tops come off in two ways...If you look, you'll see a little break in the Handle on top...that is an "inner circle" that you can spin off, and then the large black circle is the "outer circle" that also comes off. They also have a bulkhead pre-installed on the bottom of the opposite side to my picture.

I don't think they are stackable...I got them from Corix and they are made in Vancouver. Really heavy duty. I was going for other ones from Andrew-Sherat but these were just way better built. Plus the shoulder of the tank allows me to put in some additional plumbing with uni-seals without having to worry about slopes (a straight spot to drill a hole)

They will sit side by side on the small stand you see at the back of my fish room in the pic below:


I wanted just enough rise that gravity would empty them. I plan to do a fully plumbed water change system to the sump which will sit on the stand to the left. There is also a dedicated drain over there in the floor that you can see (black pipe)
__________________
Mark...



290g Peninsula Display, 425g total volume. Setup Jan 2013.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 10:23 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.