3D Printing Aquarium Parts

[ScubaSteve]

Originally Posted by imisky

With a provided slicing profile, 20 microns is perfectly fine. Now telling a new user, who has limited experience with a 3D printer and no profile is another story lol. Thats where majority of the failures occur.

Ive been wanting to try Cura (skeinpypy). I use skeinforge + slic3r but would appreciate the accelerated slicing of pypy on skeinforge as I like it way better over slic3r.

I was wondering about netfabb as I know one of the default resolution in netfabb for UM is 0.075mm. So it should allow for a person to use it to adjust for 20 micron more easily. But again Ive never seen anyone use netfabb for slicing, only to fix broken STLS.

There is a God of Ultimaker called BlueBot (Paul Candler). He was the first to do 20 um prints. He swears by Netfabb. Most of the Ultimaker camp has switched over to Cura, even to the point that the company endorses it as the official slicer.

I used slic3r and KISSlicer for a while and liked them but Cura blows them away. There are some features of the other two I wish Cura had but I could easily request the programmer (Daid) to add them. He's pretty helpful.

Give Cura a go. You'll love it.