Wayne's 105g 'Rainforest of the Sea'

[wmcinnes]

Originally Posted by sphelps

The original stand was 3/4" plywood and I recall it being pretty tight.



The marks you're referring to will probably be from the gasket as well which is small than the actual bulkheads so you have less clearance than you might think. I would account for 1" max.

A couple options I could recommend:

If you're using 1-1/2 tubing an option is to make the stand 55" x 23" meaning it will extrude 1/2" out from all sides of the tank but should give you the clearance you need.

Another option is to build up a few layers of plywood on top of the metal stand, you can drill large holes for the bulkheads and use the plywood as a spacer, not great for access after the tank is in place but an option.

Other options involve build the stand around the bulkheads or notching with added support. Or make the stand from 3/4" plywood like I did.

Either way be sure to get the bulkheads first, make sure they fit the holes properly, then measure for stand clearance. If you don't follow this order you're asking for problems.

Originally Posted by The Grizz

Thanks for the info Steve, your always great for help & ideas.

Wayne, I think making the stand a little bigger like Steve suggested as well as 2 layers of 3/4" plywood might be the best option.

Alright well I busted my butt over to Illusions after work and picked up some bulkheads. Like I originally thought, the edge of the bulkhead to the back edge of the back pane is about 1 1/4". Meaning a 1 1/2 tube is going to contact 1/4" of the bulkhead.






Thanks for chiming in Steve! I understand the theory of lengthening the stand an inch but I'm not quite sure what stacking the tank on 2 sheets of 3/4" plywood is going to accomplish.. must be having a brain fart.

I am good with increasing the stand width from 22" to 23" Greg, if that is okay with you of course!