![]() |
|
#1
|
|||||
|
|||||
![]() Looks great! I think it's a bit of a shame the return lines are drilled so low but I guess you'll just have to work with it. Just watch your creep back-flow as lockline doesn't really seal 100% at the joints, might want a check valve. Another alternative is to replace the first fitting on the inside with an PVC elbow and hard pump it up in the tank a little before using your lock-line, that way you'll be able to point your nozzles down making them more useful and should also be less obtrusive.
Would think with those light supports you could run the power wires and such through the tube. Is that not possible? |
#2
|
||||
|
||||
![]() Quote:
I want to say there was a reason I didn't put the wires through the tube, maybe I just put it off as a to-do when I installed the controller. Either that or I had already ratcheted the lights on and couldn't squeeze the cable past the bolt. I do at least have a cable hole drilled beside the return lines. ![]() |
#3
|
|||||
|
|||||
![]() Looking good dude, if you ever need some frags just give me a shout.
![]()
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#4
|
||||
|
||||
![]() Thanks! I'll be doing that for sure. rocksteveo said you live close by to me, it's nice to have a few reef buddies around.
|