Profilux stand alone doser problem, doser does not stop,,,

[Matthias Gross]

this only happens after a water damage:

either the front board (mostly the buttons) got wet or the small board inside with the western sockets got wet

in some cases it helps to clean the boards, but mostly there is too much
corrosion after a water damage and you can't be sure that the doser will work in future without problems - in my opinion a too high risk

both parts are available as spare parts

please contact your retailer for further details

[Rice Reef]

Originally Posted by Matthias Gross

this only happens after a water damage:

either the front board (mostly the buttons) got wet or the small board inside with the western sockets got wet

in some cases it helps to clean the boards, but mostly there is too much
corrosion after a water damage and you can't be sure that the doser will work in future without problems - in my opinion a too high risk

both parts are available as spare parts

please contact your retailer for further details

Thank you for your quick response. I have contacted Michael of Aqua Digitial and he has replied to me. Just before going to work this morning, I had reconnected the standalone doser and the 3 dosing pump stopped running. I had press the manual button and the dosing pump worked. I have not had the time to check if the auto dosing program will work but I intend to check it out either tonight or over the weekend. For now I had disconnected it again so that I don't overdose Mg and I'll dose Alk and Ca manually tonight. Hope it goes well...

Again, the unit was not near any water nor did it get splashed... do you recommend me opening it and have a look anyways?

Thanks

Wayne

[Aqua-Digital]

Yes - please refer to our instructions in the pm.

If in dout on opening please send very clear photos of the exposed pins of the connector cable to the front board.