Madmak's 200G Reef Build

[bauder1986]

Originally Posted by The Grizz

I would add 6 more of those feet if it was me. Reasons: there only 1/2" bolts and not structual bolts, your stand is only 1/8" thick tube & the bolts you used are very tiny and don't take much force to break.

Another solution i see greg, if you will help me with this(either criticize or elaborate) I noticed that the ends of the tubes where the feet screw into are open. What you can do to solve the issue of having all the weight transfered to only the outer edges of the tubing is insert a block like this through the ends to line up with the bolts.



The block would have to be a very snug fit but it will properly transfer the weight of the tank from the pillars down through the block and into the threaded foot bracket instead of through the pillars and into the very thin walls of the square tubing which would buckle under the weight over time.


but greg is one hundred percent bang on about the 1/2 bolts.....they should be at least 3/4" bolts.....but, if you were to insure that no more then 3/16" of thread was out it would REDUCE the risk of snapping the bolts but it wouldnt be a full garuantee....