![]() |
|
#1
|
|||||
|
|||||
![]() Thanks, I had to reposition it as the wet side was actually on the rocks, the dry side was off the tank but held up in my mess of cables. I used a new sticky pad to hold it up, realigned it and it didn't help, played around with it, walked away then turned it off, its not the alignment.
|
#2
|
|||||
|
|||||
![]() Disassemble the wet side and check for broken/worn parts.
http://ecotechmarine.com/media-galle...disassembly-2/ |
#3
|
|||||
|
|||||
![]() Hmmmm, I would take the back off the wet side, it just pops off and rinse, maybe you have something inside or stuck within the prop area.
What kind of sound is it. I just had to have a couple parts replaced (Thanks Dave @ Concept) as the nut would not stay fastened causing the drive shaft to spin within the implellor. Boy what a noise that caused, loud squeel, that go louder as the nut got looser. A new nut, that stays where it should fixed this.
__________________
![]() Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk |
#4
|
|||||
|
|||||
![]() Quote:
Thanks, I will take it apart tonight and see what happens. |
#5
|
|||||
|
|||||
![]() just be EXTREMELY careful when tightening up that plastic nut.....over tighten it one iota and its buggered....
__________________
260g mixed reef, 105g sump, water blaster 7000 return, Bubble King SM 300 skimmer, Aqua Controller Jr, 4 radions, 3 Tunze 6055s,1 tunze 6065, 2 Vortech MP40s, Vortech MP20, Tunze ATO, GHL SA2 doser, 2 TLF reactors (1 carbon, 1 rowa). http://www.canreef.com/vbulletin/showthread.php?t=50034 . Tank Video here http://www.vimeo.com/2304609 and here http://www.vimeo.com/16591694 |
#6
|
|||||
|
|||||
![]() I think its buggered anyway.....
![]() |