leaky bulkhead question

[Jason McK]

Usually bulkhead leak because they are over tight.

Gasket goes on the wet side and tighten finger tight
If this is on your 180 you might have to flush the bottom of the overflow to make sure there is no debris that would get between the gasket and the glass

J

[lastlight]

Yeah I would drain the overflow and razor blade the area where the gasket seats. Then hand tight after washing the gasket clean.

[smokinreefer]

awesome.
thanks for all the tips!

[MarkoD]

put silicone between the seal and the bulk head screw.

when it dries you'll have more give to tighten the screw and it'll make a tighter seal