|
|
|
|
|
#1
08-08-2011, 10:33 PM
|
|||||
|
|||||
I have never tried it, but in theory it might work, if he had a 0-10v PWM and connected the output to a voltage divider, it should divide the voltage and the duty cycle should remain the same. since the width of the pulse determines the voltage where 10% = 1v and 100% = 10v with an amplitude of 10v then 10% = .5v and 100% = 5v if the amplitude is divided in half. of course load is a factor so some experimentation with resistor values would be required, i would start with 10k half watts and see what happens
__________________
Crap happens, that's why they sell toilet paper in 48 roll packs! 
|
|
#2
08-09-2011, 04:56 AM
|
||||
|
||||
|
Use a simple 555 ic. Plenty of schematics out their on the web. Doesn't get any simplier than this one.
http://www.instructables.com/id/Simp...lation-PWM-Wi/
__________________
-=Bryan=-
|
|
#3
08-10-2011, 12:26 AM
|
|||||
|
|||||
|
http://www.robotroom.com/PWM.html
here is a link i just found, really simple and outputs 25ma. not sure how you could implement sunset/sunrise similation though
__________________
Crap happens, that's why they sell toilet paper in 48 roll packs! Last edited by Cal_stir; 08-10-2011 at 12:30 AM.
|
Hybrid Mode
