|
|
|
|
|
#1
06-04-2011, 02:22 PM
|
|||||
|
|||||
If there's an Andrew Sheret in Cgy they may have them, as well as JG fittings, tubing, poly replacement filters etc. I've also found a few pure water vendors carrying parts for RO systems. You just need to look around a bit. Might cost a few dollars more, but don't have to wait & if there's an issue, it's much easier to go back to the local vendor if you can find one.
Edit: My bad, I guess Andrew Sheret is a BC outfit only, no vendors in Alberta or points east. Not sure you can order from their web sites.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build  http://www.canreef.com/vbulletin/showthread.php?t=82206
Last edited by mike31154; 06-04-2011 at 02:27 PM. 
|
|
#2
06-04-2011, 03:06 PM
|
|||||
|
|||||
|
also pay attention the the GPD for the rejection rate. Below cut from here
Difference between the 50, 75, 100 & 150 GPD membranes? The major difference, besides how much water they can make, is the rejection rate. Normally, the lower the GPD volume, the higher the removal rate is. The 50 and 75 GPD membranes have about the same rejection rate of 97%. The 100 GPD has about a 90% rejection rate. The 150 GPD membrane is a different story. It allows for high volume without a big drop in the rejection rate. It has about a 97% - 99% rejection rate.
__________________
my tank
|
Hybrid Mode
