Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > DIY

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #14  
Old 02-25-2011, 05:27 AM
Palmer's Avatar
Palmer Palmer is offline
Member
 
Join Date: Aug 2009
Location: Calgary SW
Posts: 362
Palmer is on a distinguished road
Default

Quote:
Originally Posted by Delphinus View Post
Are they schedule 40 bulkheads (black) or the schedule 80 (grey I would think)?

Can you post a picture of how far in they go into the hole?

I think you can drill over the holes if need be. You'll need a plant sprayer to spray water as you go instead of the usual trapping-water thing you usually have to do. I've used the spray bottle when drilling holes on glass I couldn't get horizontal like on a tank too big to turn sideways.

No idea how risky it is.

If it's just 1mm short maybe a dremel with diamond bit to grind out the holes to make them large enough?

Or, just use the 3/4" bulkheads but step it up to 1" on either side. Would make for a small restriction but maybe not much worse than a typical 90-degree thing.
Great suggestions

They are the schedule 40 black ones. I think I am going to go with your last suggestion. I have already experienced the whole square peg round hole thing, I think I want to go with the easiest solution. thanks
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 09:01 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.