Pump vibration damping.

[matinbc]

careful with the mouse pad because of the glue, and certian foams will leech.. I would just grab a sheet of filter media from your local store and lay it on the bottom of your sump. I did and it works great.

good luck.

[mike31154]

Old used suction cups from dead heaters/powerheads etc. Most hardware & dollar stores carry suction cups too. Coil up some rubber air line tubing? Should be able to rig something up.

[Northernseacorals]

Originally Posted by mike31154

Old used suction cups from dead heaters/powerheads etc. Most hardware & dollar stores carry suction cups too. Coil up some rubber air line tubing? Should be able to rig something up.

Ditto, suction cups with plastic ZapSnaps ;-) safe and easy !

[phi delt reefer]

sand in a zip lock bag under the pump

[SeanPrest]

im using filter foam out of an old fluval i had kicking around

[cale262]

Originally Posted by phi delt reefer

sand in a zip lock bag under the pump

Awesome idea

[GMGQ]

You can also get a multi pack of suction cups from the dollar store store or Daiso. Just get the ones that come with removable metal hooks (and remove them).

[hillegom]

Originally Posted by matinbc

careful with the mouse pad because of the glue, and certian foams will leech.. I would just grab a sheet of filter media from your local store and lay it on the bottom of your sump. I did and it works great.

good luck.

My mousepad is made from the same material that wetsuits are made of. One piece, no glue holding little pieces together. I thought they were all like that until I had a look at others.
Right, you do not want glue dissolving in the sump

[monocus]

use neopreen-buy it at rona or home depot-use i/4 " thick

[Rogue951]

I ended up just tying some airline around it on each end of the pump lol. I'll make it look nicer later.

Thanks for the brainstorm!