Quote:
Originally Posted by mr.wilson
Paul's adaptation of his Revolutions product to an inline solution for you is nothing short of pure genius. His best ideas are inspired from specialized requirements like yours.
Lexan will still warp. I have used lots of these lids over the years.
Remember those are the Seaswirl flow limits, not the limits of the Dart to push water through a Seaswirl.
I did a 600 gallon acrylic tank (96x30x48) a few years ago, using two darts on 2 OM 4ways, with a Blueline 100 return pump. Flow was excellent. Use an online head loss calculator to make sue you are getting the best out of your system.
Use threaded parts where you can so it is easier to adapt to change.
|
did you have that motorized valve on there
__________________
180 starfire front, LPS, millipora
Doesn't matter how much you have been reading until you take the plunge.
You don't know as much as you think.
Last edited by Skimmerking; 01-09-2011 at 12:09 AM.
|
01-03-2011, 02:34 AM
Threaded Mode
