Stupid Question Concerning Overflow Plumbing

[mark]

if this standpipe is in a overflow chamber that's all the water the will flow into the sump. Easy enough to calculate the volume of the chamber and if your sump has remaining room.

[Madreefer]

I should have mentioned that the overflow is full of water and there is some slots at the half way point to allow water to go inside. So the tank will drain to that point. Like I said "stupid question". So I think the only answer is the ball valves that I would have to put in before I remove the pipes.

[mark]

seen some overflow chambers that are doubled layered, slits on bottom outside piece then water flows over the top of the inner layer.

Would seem rather silly that the slits on yours would be all the way through. Not a smart way to build overflow.

[Madreefer]

Originally Posted by mark

seen some overflow chambers that are doubled layered, slits on bottom outside piece then water flows over the top of the inner layer.

Would seem rather silly that the slits on yours would be all the way through. Not a smart way to build overflow.

Thanks Mark yes it was double walled. I was able to take out both drains and both pipes from the return lines. I tried to vacum out as much of the sludge on the bottom but it was too thick for my "tank only shop vac". I poured a half a bucket of fresh water in the overflow and this is the water that came out that came out. This is after sitting in the bucket for 1hr.


After pouring water out this is the 2" of sludge that was left that was filled with some pretty big bristtle worms.


This tank has been setup for about 3 years. How often do you people clean out your overflows? I've never thought of it.