Looking for someone to teach how to cut 1/2" glass.

Ya new glass is easier than old also the thicker the glass the easier it is I don't even tap it I just put it on the edge of a straight edge and bring mu hand down on it not to hard it should go click and presto you have cut glass.

Bill

[Gary]

Not sure about scoring the glass two or three times. I have been working with glass for over twenty years and I was always told - Never go over your score. It will give you a bad break and wreck your glass cutter as well.

[reefwars]

Originally Posted by Gary

Not sure about scoring the glass two or three times. I have been working with glass for over twenty years and I was always told - Never go over your score. It will give you a bad break and wreck your glass cutter as well.

Have heard the same thing one score equals clean break if you score over the same line more than once it can be a jagged cut. The same rule applys when cutting stone cheers

[sphelps]

Definitely only score glass once. It's a lot easier if you have a glass cutting table but I did hear a trick once regarding cutting thicker glass. After scoring spread some lighter fluid over the scored area of the glass and lite it. Apparently that will snap it perfectly, never tried it myself just heard it's pretty common when the proper tools aren't available.

[reefwars]

Originally Posted by sphelps

Definitely only score glass once. It's a lot easier if you have a glass cutting table but I did hear a trick once regarding cutting thicker glass. After scoring spread some lighter fluid over the scored area of the glass and lite it. Apparently that will snap it perfectly, never tried it myself just heard it's pretty common when the proper tools aren't available.

Humm now that is cool very interesting , learn something new every day

[DiverDude]

Originally Posted by bvlester

Ya new glass is easier than old also the thicker the glass the easier it is I don't even tap it I just put it on the edge of a straight edge and bring mu hand down on it not to hard it should go click and presto you have cut glass.

Bill

I would be VERY careful doing this. Be sure to wear gloves. I've heard of people doing this with the palm of their hand and as the cut piece gives away, they slit their wrist on the new, sharp edge !!!

[Binare]

I do it on a flat surface with a 1/4 dowel under it that runs the entire length of the break. Press down and done. It don't take much to snap it and its a lot safer.

[reefcanada]

Wow, If you like I will cut it for you. I have been in this trade for 15 years and I am not so keen on just giving my trade away. As for lighter fluid, You would want to use methyl hydrate. As it burns faster, but you only use this for laminate glass to burn off the plastic in the middle. You will need a heavy float cutter, cutting oil, cold chisel and a hammer. shoot me a pm and we can talk. Thanks

[Binare]

Originally Posted by Binare

I do it on a flat surface with a 1/4 dowel under it that runs the entire length of the break. Press down and done. It don't take much to snap it and its a lot safer.

Thats of course AFTER scoring it, and only scoring it once. I REALLY hope that part was too obvious to mention for everyone who read it

[ALBERTA REEF]

I have tried cutting !/2" glass in the past With a crappy wheel cutter from Home Depot. Just say it did not turn out will. What is a good glass cutter and where to get one?