Diamond hole saw

[Dyspnea]

Originally Posted by monocus

remember you get what you paid for-if it is for a one time use then no problem-but if you are going to be doing multiple cuts i would go for a more expensive one-you also have to look and see if it isn't warped-i bought a dewalt (really crappy company now)6 " hole saw and it was off center by 3/8 of an inch.at the same time i bought a set of diamond hole saws at summit tools(8 different sizes) for around $80 and they have worked out fine-but i wouldn't use them more than 4 times before replacement.the average diamond holesaw runs about $80

I have to disagree of this, I bought two hole saws on Ebay, shipped for 25 dollars. They were "cheap" but very well built. I used them to cut four holes each and to be honest they could probably do 2-3 more each. Paying more isn't alway going to give you better quality.

[xtreme]

I have gotten a number of out holes out of the "cheapies" so they aren't that bad.

Garry, if you are looking for hole saws check out mops.ca. I think they are the same as the ones BRS carries but will cost you less.

[Seamazter]

Thanks mate.

[Kenzy]

Originally Posted by xtreme

I have gotten a number of out holes out of the "cheapies" so they aren't that bad.

Garry, if you are looking for hole saws check out mops.ca. I think they are the same as the ones BRS carries but will cost you less.

I bought an 1.5" hole saw from MOPS and it worked great. The best part is no duties to pay.