First ever Saltwater, 90g

[Blom]

Okay, done the plumbing. In the process of testing it, and an hour in and still no leaks

Going to start filling it up tonight with RO water. Planned on picking up my lights next week, I was thinking of the Tek T5 48" 6 bulb x 54w. Seems like quite a few people went this way. I was thinking about HQI but just didnt want to get into all the problems of heating the water up to much. The Tek will end up giving my just over 3 1/2 watts/gallon on the conservative side. The only question I had is whether or not the light would reach deep enough (23" maybe 20-21" with sand) for say some clams

Another question I was going to ask the very knowledgeable people on this forum is what they were using for test kits. Which brand do you you like and why?

Thanks
Tyson

[fishytime]

My tank is 20" deep 12x39w (six each side),most of my clams are on the bottom. Have some sps in the lower half of the tank too. You shouldnt have a problem running 6x54w. Depending on what clams you were thinking of, crocea and maxima prefer to be on rock anyway. So, unless you find a super flat rock to put them on at the bottom of the tank, they will likely be up a bit.

[JDigital]

Originally Posted by Blom

Okay, done the plumbing. In the process of testing it, and an hour in and still no leaks

Going to start filling it up tonight with RO water. Planned on picking up my lights next week, I was thinking of the Tek T5 48" 6 bulb x 54w. Seems like quite a few people went this way. I was thinking about HQI but just didnt want to get into all the problems of heating the water up to much. The Tek will end up giving my just over 3 1/2 watts/gallon on the conservative side. The only question I had is whether or not the light would reach deep enough (23" maybe 20-21" with sand) for say some clams

Another question I was going to ask the very knowledgeable people on this forum is what they were using for test kits. Which brand do you you like and why?

Thanks
Tyson

90G in a basement, correct? You shouldn't have a problem with Metal Halides... I am running 2x250W HQI's on my 75 and see very little fluctuation in my temps. 1.5 degrees at most.. 25-26 at night and 26-27 in the day. Plus a set of 2x54 T5s...

Test kits for me.. Salifert for Alk and Mag, Elos for Ca, pH, NO2, NO3, NH4..

[fishytime]

Originally Posted by JDigital

90G in a basement, correct? You shouldn't have a problem with Metal Halides... I am running 2x250W HQI's on my 75 and see very little fluctuation in my temps. 1.5 degrees at most.. 25-26 at night and 26-27 in the day. Plus a set of 2x54 T5s...

Bah.....go T5

[JDigital]

Originally Posted by fishytime

Bah.....go T5

Yea, for supplemental.....

[Blom]

Hah, Forum fight. Taking bets...


I think ill stick with T5s, its going to give me the light I need with less wattage which means a happier enmax bill! Pfft on the fitting with the RO unit, or maybe pffft on the plumbing in this 30 year old house. either way im heading back to Rona. Im going to see if they have a gold card for people that are in there every day. Thanks Josh for the test kit, ill take a look at it.

[Blom]

Yup, Sh**y plumbing in the house. Which got me thinking about the wiring, I might run into breaker troubles once everything is running. Two fishtanks (albeit the FW is not running alot of wattage compared to what the SW will be running) and a jacked up computer. I guess we will see. Started filling the tank with RO water. I feel bad for people with huge tanks, this must take forever.

[fishytime]

You should borrow Greg's(Snappy aka Coral Master) RO unit I think he said it does 300gpd. Nothing like waiting for water to drip huh?