|
|
|
|
|
#2
03-09-2009, 06:45 PM
|
|||||
|
|||||
I'll try and get a pic tonight.
I'll try the Dremmel hopefully it will work. Strange how it has happend almost 3 years after I set it up though J 
|
|
#3
03-09-2009, 08:13 PM
|
|||||
|
|||||
|
Pictures ? How are you planning to repair it? I've never had any luck with acrylic and dremels, trying a variety of different tools. If it starts melting, you get stuck in that one spot
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
|
#4
03-09-2009, 08:18 PM
|
|||||
|
|||||
|
I'm not even sure a demmel will get in there. I may just use a hacksaw
J
|
|
#5
03-09-2009, 08:35 PM
|
|||||
|
|||||
|
Yikes, good luck, I hope it works out for you.
__________________
One more fish should be ok?, right!!!  - Laurie
|
|
#6
03-09-2009, 08:54 PM
|
|||||
|
|||||
|
Is it just the teeth that need to be trimmed on the front and/or back?
 If it's just a few teeth you may get through it with out melting too much, if you can get in there. Using a hacksaw blade might work the best, I have a bunch of new blades including some very fine toothed ones. LMK if you want me to bring them over.
|
|
#7
03-09-2009, 09:29 PM
|
|||||
|
|||||
|
Hey Cprowler thank for finding the pic. You can see where the brace goes over the teeth. It's gonna be though to get in there.
After thinking this through all day. I think it's always been like that. Last week I was hanging in the tank quite a bit and might have put a lot of pressure on the back brace. This could have cause it to crack. I'll follow up in the morning with my progress J
|
Hybrid Mode
