|
|
|
|
|
#1
01-27-2009, 04:45 PM
|
|||||
|
|||||
best advice is to look under plastic in the yellow pages.
http://www.yellowpages.ca/search/si/1/plastics/manitoba heres a couple Laird Plastics 8 Plymouth Street, Winnipeg, MB R2X 2V7 Telephone : 204-632-1136 Acryl Design Ltd 740 Century Street, Winnipeg, MB R3H 0M1 Telephone : 204-783-6064 Free Call if you look at the link i posted, i'm sure you'll find something closer to you, good luck.
__________________
` 120S RR tank with 60G basement sump / fuge Return Pump: Little Giant 4-MDQX SC Water Movement: Seio 1500, (2) Hydor Koralia 4's Lighting: 400W SE MH with 14K Aqua Connect Skimmer: Euro-Reef RS250 with gate valve Other: RODI, RDSB, PO4 / AC reactor 
|
|
#2
01-27-2009, 06:15 PM
|
||||
|
||||
|
Nice thing about going with a plastic shop is that most can cut the acrylic for you and then ship it. As for tube it's harder to find but keep phoning around, out here my experience is that you can't buy tube pre cut you have to buy the length.
Douglas
|
|
#3
01-27-2009, 06:54 PM
|
|||||
|
|||||
|
Finally! LOL this thread is 2 months old...
Thanks, I appreciate the replies...  I never though of the yellow pages, DUH! I will ask sphelps, he does live in Saskatoon which is only 5 hours away.
__________________
Calvin --- Planning a 29 gallon mixed reef...
|
|
#4
01-28-2009, 04:12 AM
|
||||
|
||||
|
I used to play around with acrylics back in the 80's so my memory might be off but for solvent I used methylene chloride which is also known as dichloro methane. At that time I worked at a lab so I always had it handy. For uneven joints I used to take the cuttings from my jigsaw (the powdered acrylic) and disolve it in a small bottle of solvent, the more you add the thicker the solution. It also dries completely clear, no need to purchase glues of varying consistency, just make your own
|
Hybrid Mode
