|
|
|
|
|
#2
12-31-2008, 02:45 PM
|
||||
|
||||
Machete, My temp probe worked fine on my acjr until I reset the memory by accident.
Ever since, my tank has been reading 5 degrees higher than what the normal params were for me prior to the reset. My swing/change is obviously not as dramatic as yours, but definitely the same issue with the same piece of equipment. I'm going to compare to an analog thermometer I have and one of those 20 dollar digi units as well. I'll drop you a pm and let you know what I figure out. 
|
|
#3
12-31-2008, 02:47 PM
|
|||||
|
|||||
|
My Aquamedic temp controller does that after a power blip. but unplugging for a while usually fixes it. Lucky thing you had fans on to cool it. I boiled some livestock last time it happened to me :
__________________
Dan Pesonen Umm, a tank or 5
|
|
#4
12-31-2008, 03:57 PM
|
|||||
|
|||||
|
tryed turning it off also reset the memory. when i unplug the prob it drops to 6 then when i plug it in right away it jumps to 60 then 100 then 120 i can take the prob out of the water and dunk it in snow and it still sits at 120..... i think i just need a new one.... i hope... anyone know how much they are... jls page is down and i dont think there open till 11
|
Hybrid Mode
