![]() |
|
#1
|
|||||
|
|||||
![]() I've been trying to fit 50 gallons into a 20 gallon container for at least 20 years and cant figure it out, if you can please share.
|
#2
|
|||||
|
|||||
![]() you need to use the square 20g. 50 gallons won't fit in a round 20g container, I've tried.
__________________
Brad |
#3
|
|||||
|
|||||
![]() Quote:
![]() ![]()
__________________
One more fish should be ok?, right!!! ![]() Last edited by fishoholic; 12-15-2008 at 04:18 PM. |
#4
|
|||||
|
|||||
![]() I'm pretty good with the RO but I have a habit of shooting water out of the tank with powerheads while blowing off the rocks.
__________________
Robb |
#5
|
|||||
|
|||||
![]() Quote:
Oh for Chrissakes; why didn't you tell me this earlier? |
#6
|
||||
|
||||
![]() Doesn't anyone have timers in thier houses? It takes me roughly 73ish minutes to fill an 18L water jug, so I set the timer on the microwave for 73 minutes and go down and wait 2 more min for the last 3 inches or so. Haven't spilled a drop yet.
|
#7
|
|||||
|
|||||
![]() The day before I spent time downstairs with my iphone stopwatch timing how long everything fills. Then an alarm would go off when the time went by... The next day were downstairs and I didn't bring the phone down with me.
![]() Its a no brainer to time things, but I never said I had much for brains to begin with. ![]() |
#8
|
|||||
|
|||||
![]() Oh ya, I would go to bed and flood the kitchen floor with RO, the worst was when a prestage filter burst in the RO unit and the flow rate went up 400%, my 2hr brute can fill took 30mins, and I noticed it an hour too late
![]() |
#9
|
|||||
|
|||||
![]() I am solving my problem once and for all, I just got back from the plumbing store with a soleniod water valve that will hook up to a float switch, when the reservoir is full the water is automatically shut off, total cost $35.00.
|
#10
|
|||||
|
|||||
![]() ![]() ![]() ![]() ![]() |