![]() |
|
#1
|
|||||
|
|||||
![]() Freshwater has been running for a couple of hours now and no leaks. Overflow is quiet as can be. Eheim 1262 pump is completely silent.
Now, here pics of the noise problem. Extremel noisy where the water is entering the sump. There are no leaks in any of the fittings, so I cannot figure out where the air bubbles are coming from. This is the same problem I had with the Durso. Changing the gate valve only raises and lowers the level in the overflow, but does nothing to eliminate the noisy bubbles. I'm sure that once I figure out how to eliminate the turbulance coming from the bottom of the drain, this will be a very quiet system. Here's the water coming out of the bottom of the drain. (ABS is being used until I figure out how to solve this problem) Here's the bubbles that have risen to the top. The white hose is the emergency drain. The water level in the overflow is just touching the top of the drain, but no water going down.
__________________
![]() 10 Gal Nano Contest: http://www.canreef.com/vbulletin/sho...d=1#post348308 90 Gal Corner Pentagon Build: http://www.canreef.com/vbulletin/showthread.php?t=42263 |
#2
|
|||||
|
|||||
![]() To elimiate the noise, Slice little slits in the pipe that is submerged int he sump. this will allow for the air to escape theline before being plunged into the sump.
you will still obviously get air bubbles, but super quiteer. ![]() ![]() anyone else have any suggestions? Last edited by Interior_Reef; 11-30-2008 at 06:02 PM. |
#3
|
|||||
|
|||||
![]() Here's the drawing of the sump. Quietone pumps were changed to a single Eheim.
![]()
__________________
![]() 10 Gal Nano Contest: http://www.canreef.com/vbulletin/sho...d=1#post348308 90 Gal Corner Pentagon Build: http://www.canreef.com/vbulletin/showthread.php?t=42263 |
#4
|
|||||
|
|||||
![]() ![]()
__________________
Doug |
#5
|
|||||
|
|||||
![]() Did some experimenting tonight and found if I changed the drain size from 1 1/2" to 1" in the overflow and added a tee to the bottom of the drain, it is quiet as can be. The water level in the back is set just below the top of the emergency drain. The only thing I can hear now is the Eiheim pump and it is very quiet.
So we drained the freshwater and started to put the light rack back together. With any luck I should be starting to put saltwater in it tomorrow night.
__________________
![]() 10 Gal Nano Contest: http://www.canreef.com/vbulletin/sho...d=1#post348308 90 Gal Corner Pentagon Build: http://www.canreef.com/vbulletin/showthread.php?t=42263 |
#6
|
|||||
|
|||||
![]() Looks Like a nice set up what are you planning with this one mixed reef?
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |
#7
|
|||||
|
|||||
![]() Congrats on getting the noise level down to an acceptable level, sounds like it was a frustrating experience with lots of experimenting. Sometimes that's the only way since every system is different in it's own little way.
Good luck with the rest of the build, it looks great so far. |
#8
|
|||||
|
|||||
![]() It will be a mixed reef. I have a dozen or so SPS's, a few LPS'S and I like zoanthids and mushrooms. So I guess mixed it is.
The one thing I am really unsure of is which fish to stock it with. It's hard to make a decision when you like them all.
__________________
![]() 10 Gal Nano Contest: http://www.canreef.com/vbulletin/sho...d=1#post348308 90 Gal Corner Pentagon Build: http://www.canreef.com/vbulletin/showthread.php?t=42263 |