Acrylic Router Bits

[Chad]

The best way for me to describe it is more of like a "wave" action. I don't see bubbles. I have no way to increase the router speed.. maybe I should get a new router?

[sphelps]

Originally Posted by Chad

The best way for me to describe it is more of like a "wave" action. I don't see bubbles. I have no way to increase the router speed.. maybe I should get a new router?

First try removing less material and a slower feed rate.

[Chad]

I will give it a try, I know if I go to slow it starts to melt it. I wish you could automate the feed rate :-)

[Chad]

I went out and bought a spiral up-cut bit from Freud. It seems to do a much better job.. very smooth.. I am going really slow as well...

[kari]

Megadream is into routers and wants to help out?

The best solid carbid bit I have found was the Onsrud upcut spiral. Since you are using a table, a bit with a flush trim bearing is useful for template cutting.

[dareefguy]

I can see how this just turned sexual. lol

[brizzo]

Good to know the upcut spiral bits do the trick. I had been considering giving the up/down cut bits a try.