My first acrylic project.

[Dale D]

More ?'s

I can't see it in any of your pictures, but, what did you end up using for the air control valve on the beckett housing?

I just finished the injector housing for mine and now just have to find an air valve for it.

I guess it shouldn't matter if the valve is in the lid of the housing or in the side of the tube. I looked at a Bullet skimmer yesterday and I think it was in the lid.

Also I'm not sure if I am going to use an injector pipe in the first reaction chamber or the swirl injector design. The swirl design looks fancier. ops: