|
|
|
|
|
#1
05-16-2008, 02:31 AM
|
|||||
|
|||||
clint
two possible ways: - if the difference is 1/4", then put a 1/4" thick x 4" wide piece of wood all the way across the stand of the lower side at the bottom. You can get these in or near the moulding section or the primed pine wood area at HD. - temporary nail a fence up around the top of the stand all the way around and pour in self-leveling compound. that stuff is suppose to be pretty good with the leveling and very strong because its made to be thin
__________________
____________ If people don't die, it wouldn't make living important. And why do we fall? So we can learn to pick ourselves up. 
|
|
#3
05-16-2008, 03:43 AM
|
|||||
|
|||||
|
Is it the floor or the stand that is uneven? If its the floor, I think it would be easiest to use shims to level the stand. You can get large size shims, 5 to 6 inches wide. They go from 1/8" at one end up to 3/8", they all vary.
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
Hybrid Mode
