RODI problem

[Tangman]

you must have some thing in backwards, did you some how muck up the flow restrictor ?

[Chowder]

Not that I'm aware of. I have put the PSI gauge to the input and have 40 plus PSI comming off the tap but it is about 10 PSI after going through all the prefilters. It pretty much trikling out of the RO membrane. So I would imaginre that it would be something in the prefilter section. Took it all apart this morning to see if I could find a blockage but didn't notice anything.
Thanks, Chris

[Sebae again]

Normal house pressure should be 60 psi. after the PRV. Not sure what your street pressure is but it should be more than 40 . What's your pressure in the rest of your place, ie. outside hose bib [ tap ] Do you have a high pressure hose bib that comes off before your PRV if so what is the pressure there.

[Chowder]

I am in a appartment and I don't have a outside hose bib. I couldn't get an accurate reading with the PSI meter because the fitting leaked to much. I could read 40 PSI but there was water spraying everywhere. I assume it would be higher if I could get a good seal.
Thanks, Chris

[Sebae again]

Maybe some DI beads got into somewhere. I assume you have back flushed the system.If you used a needle valve on the supply some sediment or rust could have gotten in there.You may have to take all the lines apart and flush each one out seperate.

[Chowder]

I took apart the unit this morning. I cleaned out all the beads made sure all lines were unblocked. I started the unit earlier about 7-8 hours ago and am at about 2 gallons. I also emailed Aquasafe and am waiting to see what they say.
Thanks, Chris

[Captainhemo]

try remving all the pre filters, the membrane, and Di . Then see if water passes freely through the system. If so, start adding filters , starting at prefilter until you find the problem.