Thanks for the advise. I read through a few articles at the top, and then a few more that Randy told me to read through. I figured out what's up with the alk/ca levels, but I am still not sure what caused the pH drop before all of this. However, I should have added apH raising agent that does not effect alk, but my mistake! I am thinking I may just reset the whole system, as I am having a very hard time getting the calcium off the glass. I could do it, but it would just go back into the water column, and it's on the silicone as well. My only other option is to wait and see if lowering the alk, which is going to take atleast 3 (if not more) 50% water changes will bring the ca back into solution. I think it just may be easier to reset the system, and a whole lot less water. What do you think?
|
02-26-2003, 06:15 PM
Threaded Mode
