"Coil Of tubing" Ozone "Reactor" Questions

PzReefer · #1 12-15-2007, 06:50 AM

Yeah even 50 ' will be a lot of head pressure for a power head.
i still like using my old venturi valve skimmer as my ozone reactor and run it very dry for skimmate and I use a very large needle wheel for skimming wet.

Al

GreenSpottedPuffer · #2 12-15-2007, 07:50 AM

Quote:

Originally Posted by PzReefer

Yeah even 50 ' will be a lot of head pressure for a power head.
i still like using my old venturi valve skimmer as my ozone reactor and run it very dry for skimmate and I use a very large needle wheel for skimming wet.

Al

Yeah I realize this now...Im going with a MAG 5 I think. Should be more than enough from what I have seen people using. Need a valve most likely to tone it down a little even.

Yeah an old skimmer is nice and easy but the reaction time is way too short. Im looking to increase the reaction time to around a minute before releasing back into the sump. I would guess most skimmers are not even 20 seconds. Could be wrong but I know they are not over a minute. Plus this is much, much cheaper!

Bryan · #3 12-15-2007, 05:47 PM

How will yuu be introducing the ozone to the tubing. A venturi isn't going to do much at the low flow rate. perhaps introduce the ozone before the impeller so it gets "chopped" up. If so, expect the impeller rubber and plastic to harden and brittle fairly fast.

Pescador · #4 12-15-2007, 06:34 PM

According to the Holmes article he did not have enough flow for the venturi to suck ozone and still had to use an airpump. He was using a T from his return, twin Iwaki's 30's in series.

GreenSpottedPuffer · #5 12-15-2007, 07:29 PM

Quote:

Originally Posted by Pescador

According to the Holmes article he did not have enough flow for the venturi to suck ozone and still had to use an airpump. He was using a T from his return, twin Iwaki's 30's in series.

Really? Where did you read this? I read that whole article and he left off by saying it did a great job raising the OPR and he never smelled the ozone at all. Was there another article that he mentions that?

Pescador · #6 12-16-2007, 05:58 PM

Quote:

In this setup, the venturi simply acts as an inlet for the pumped air because the flow rate is too low to actually get any suction by venturi action.

2nd last paragraph of coil tubing reactor section.

GreenSpottedPuffer · #7 12-15-2007, 07:27 PM

Quote:

Originally Posted by Bryan

How will yuu be introducing the ozone to the tubing. A venturi isn't going to do much at the low flow rate. perhaps introduce the ozone before the impeller so it gets "chopped" up. If so, expect the impeller rubber and plastic to harden and brittle fairly fast.

Well you are just using the venturi as an inlet for the pumped air/ozone. The flow rate is too low to actually get suction form the venturi but that not what your looking for. Its simply to get the ozone into the water.