|
|
|
|
|
#2
06-21-2007, 02:53 PM
|
||||
|
||||
Hiya
ASAP I understand matthias is still working on them. We have WLAN up and running in the UK on a test bed using the new software with no issues, looks like the release is going to be a real breeze! Regards Michael 
|
|
#3
06-23-2007, 09:51 AM
|
||||
|
||||
|
EVG-AP2 version 4.xx
Matthias Gross
i have read the spec sheet for this and would like to know if it was possible to connect two ballasts to one relay control set leaving one side unsed. i am aiming to utilize one port to control two ballasts from the profilux , and then add a led bar on the second port,using a splitter YL2. Himat
|
|
#4
06-30-2007, 09:30 AM
|
||||
|
||||
|
You can connect several ballasts to one EVG-AP output. The only limitation is the inrush current of all connected ballasts (in sum). It must not exceed 100A, with good ballasts you should not have a problem with up to 5 ballasts on one relay. The inrush current of a ballast is usually given in the datasheet.
But why do you want to use a splitter and only one relay? Do you use L3L4 for other devices? If not there is no need for this configuration. And: The new (W)LAN-tutorial - german version - is finally ready. Today we translate it, in the evening we will publish the english version. I'll post later again when it can be downloaded.
|
|
#5
06-30-2007, 08:06 PM
|
||||
|
||||
|
thank you
Matthias Gross i have used one relay for one ballast ,i didn 't know that my lights where configured so one tube from each side come on with one ballast, works better than i thought. i know need to find out how long i need to burn the tubes before dimming these are Giesemann Infiniti range 60cm. i have set 100 hrs from the manual of the profilux. thanks himat
|
|
#6
07-01-2007, 05:09 PM
|
||||
|
||||
|
100 hours are ok for burning in
And finally: The WLAN/LAN-tutorial can be dowloaded here: http://www.ghl-kl.de/Produkte/Aquari...AN_new_eng.pdf Please excuse this translation to english - in a next step we will get it "debugged". But it was important to publish this doc ASAP and i think it can be understood.
|
|
#7
07-01-2007, 06:15 PM
|
||||
|
||||
|
Wlan
I still confuse with how to set up.
How do set set the IP address? where do I get the IP address from?or just set any number? how come this thing so complicated? Matthias, is there a customer service or phone number I can call to get help for setting up? Thank you Lam
|
Hybrid Mode
