Profilux II plus aquarium controller - Page 47

monitors-direct · #**461** 06-07-2007, 09:07 PM

Back to the thread i guess

Just finished debugging the fan breeze instructions into English if anyone wants a copy

Regards
Michael

support@proline · #**462** 06-07-2007, 09:18 PM

No Prolem Colin
We are all in this together

I am pulling for you.
(Reminds me of RED Green show)

Reefer Rob · #**463** 06-07-2007, 10:49 PM

Too temping to respond to line about the 18 year old

..... but I won't.

Raul-7 · #**464** 06-08-2007, 02:57 AM

Quote:

Originally Posted by monitors-direct

Back to the thread i guess

Just finished debugging the fan breeze instructions into English if anyone wants a copy

Regards
Michael

Can I control any fan that uses an AC/DC adapter with Propeller Breeze Control module?

And must I buy the LED's made by ProfiLux or can I use any dimmable LED light?

jdjeff58 · #**465** 06-08-2007, 03:22 AM

I have been attempting to display a graph of my parameters and all I can seem to get after I 'read and save data' and then 'display graphics' is ......

a graph where all the data is drawn on the left most vertical axis. It is not drawn across the page in alignment with the predetermined time stamps. The graphs are complete with times, parameter names, and units. But the red line that appears to represent the actual measurement data is not readable in terms of units vs. time. It's just a red line that keeps drawing over itself on the 'zero time' axis.

Anyone have any luck with this. I tried exporting the data to excel and build a graph over there. But it became so cumbersome and illegible that I finally gave up. Should I be able to see a graph with out having to build one in excel? If so...how do I get it to display properly.

monitors-direct · #**466** 06-08-2007, 08:15 AM

Quote:

Originally Posted by Raul-7

Can I control any fan that uses an AC/DC adapter with Propeller Breeze Control module?

And must I buy the LED's made by ProfiLux or can I use any dimmable LED light?

Hi

As far as I know you can only use the profilux fan via the controller, this is due to potential overload.

The GHL LED's are designed to plug straight into the back of the profiLux via western connections, as GHL are the only holders of the wiring of the plugs it would be unwise to plug third partyy equipment into the back of the profilux, however there are third party adapters for the control of 1-10V supply lines for imming lights

If you let me know what you wish to achieve I can guide you better

Regards
Michael

himat · #**467** 06-08-2007, 09:14 AM

Quote:

Originally Posted by himat

Hi Guys

Have i got this correct eventuly i will whant to connect two dimmable balasts using EVG-AP2, one LED Bar, one fan control, one tunze pump.
all this using splitters

thanks
himat

Michael

can you confirm this above so i can gear up to get the right bits
also any simple quides to follow to achive this

thanks
himat

monitors-direct · #**468** 06-08-2007, 01:56 PM

Sounds fine to me

Regards
michael

himat · #**469** 06-08-2007, 04:48 PM

Michael

any info about the splitters

thanks
himat

Lam'sreef · #**470** 06-08-2007, 05:13 PM

I am still waiting for the new firmware and software to set up my ProfiLux Plus II controller with the WLAN.
Hope it come up with the easiest procedure for that.

Please let me know if that posible this weekend.

Thanks

Lam