Profilux II plus aquarium controller

[monitors-direct]

Until version 3.3 is launched I think it requires an elelment of good IT knowledge but the new releases due very soon will make it so much easier.

One thing to note and I think this statement is very accurate and also shows a level of care from the manufacturers. matthias has not yet failed in getting one single client connected as far as i am aware. If you want help in getting up and running please either contact me at support@ghl-profilux.com or contact Matthias directly, to be honest at present Matthias will be your best bet, he wil baby step you through it im sure

[Matthias Gross]

Hi

i hoped that version 3.02 could make it easy to establish the WLAN-connection.
I am writing the version 3.03 (ProfiLuxControl & firmware) with new extensions regarding LAN/WLAN at the moment. Please give me some more days for that job.
3.03 is coming soon.

[Lam'sreef]

I've spoke to Steve and he said wait fir about a week 3.03 3.04 and 3.05 should be out soon and hopefully it help set up the WLAN better.
I am looking forward to it.

Thanks

Lam Ly

[himat]

can some please provide me with english instuctions for GHL fan controller
ps will this control the fan ,fast slow or, on / off

thanks
himat

[Lam'sreef]

Hi guys,

where can I look for the IP address?

Thanks

Lam

[Matthias Gross]

@Reefer Bob:
Firmware 3.03 will support temp.-dep. shut off for MH. Yesterday i finished programming of the new dosing pump functions, i think today i can implement the temp.-dep. functions.
@himat:
The fan controller regulates the RPM of the fan continiously, that means: very hot - very fast, a little to hot - slow, temp. ok - off
@Lam's reef:
You can look with the program "DeviceInstaller" for the address. But i recommend to assign the address first (then you don't need the DeviceInstaller):
You can assign the IP using the keypad of the ProfiLux - under menu extras - communication (please see instructions regarding this). This is possible since firmware 3.02. The IP-assignment is not possible over ProfiLuxControl, it can only be done on ProfiLux directly!

[himat]

Hi Guys

Have i got this correct eventuly i will whant to connect two dimmable balasts using EVG-AP2, one LED Bar, one fan control, one tunze pump.
all this using splitters

thanks
himat

[Lam'sreef]

Hi Matthias,

I spoke with Steve and he said version 3.03, 3.04, and 3.05 should be out for about a week.
Hopefully it makes it easier for the setup, Also I note the 3.02 version did not have the Degree F setting it only have the Degree C Hopefully on the new version will have that include.

Thanks

Lam Ly

[Reefer Rob]

Hi Matthias

Will 3.03 have the temperature dependant shut off of metal halides? We're into the the high 20s in the afternoon here now, makes me really nervous with no chiller.

Rob

[monitors-direct]

Instead of stresing fish with shutting the lights off, why not go for the GHL ProfiBreeze with fan controller, this will then shift all heat from the lights away from the water surface.