Drilling glass - need some help/advice

SerLunchbox · #9 04-22-2007, 03:01 PM

Yeah, I have a very powerful dremel tool right now. Spins very fast at maximum speed.

So, about my plumbing question.

Quote:

Originally Posted by SerLunchbox

would a hole in one end (for intake about 2" down from the top) and then plumb it so that there is another hole in the center and in the other corner (hopefully put a SQWD in there to assist) and have a 90 degree elbow so that there is no back flow (for if the power goes out and the return pump stops working). So am i correct in doing this way so far?

Am I correct?