Joe Reefer's Inwall 120 V2.0 (Updated)

Joe Reefer · #1 02-13-2007, 08:18 PM

The was no real reason for the extra bends on the return side of the pump. I did know how I wanted the supply manifold postioned so this was what drove the pump location. On a side note the pump performs better than I expected and is amazingly quiet.

The upper prop tank drains into the fuge below then out the side of the fuge back to the sump.

I know the glue job looks bad but there was not one leak when I tested the tank with fresh water and to be honest I planned on painting all the plumbing when done, but it probably isn't going to happen now.

Murminator · #2 02-13-2007, 08:50 PM

Musta finally got cold enough to motivate you to get it outta garage so you can park in there huh?

Looks awesome man I love this set up can't wait till everything is moved over

Delphinus · #3 02-13-2007, 08:56 PM

The glue job looks fine, I didn't mean to imply otherwise. Just that I thought you had done all clear primer/cement until I had a closer look.

Ok so if the line I was thinking was the fuge feed isn't ... is it just an extra line for "just in case"? On your manifold it's the one on the left. I see a pipe extend out to the filter sock but I can't make out where it goes from there. That's the one I was asking if it's capped off?