MJ1200 as return for sump

[BCOrchidGuy]

As a sump return you don't need to have the 10x tank capacity. In your tank you should have at least 10x the capacity for flow but a lot of your flow needs are determined by the coral that you keep. In my old 90 gallon I had in the area of 3000GPH flow but a lot of that was behind rocks and in tank plumbing. Having say a Mag9 would be overkill in my opinion. Yes you'd have tons of water movement but in my opinion you'd have to much water flowing through the sump. Granted the MJ1200 is a bit on the small side for your needs I'd say your sump flow should be fairly limited but again that is determined by what you are using the sump for. If you intend for it to house heaters, filtration, DSB, Macro algaes then you'll want a slower water flow but if you just want it as a holding tank to aerate your water then you'd want a lot more water flow.

For my 60 gallon I'm using a Mag5 return but my sump is going to contain my skimmer, a coil denitrator a Kalk reactor, auto (gravity fed) FW top off and probably a refugium with a DSB and Macro Algaes. My sump is a 20 gallon long and my refugium which is seperate is about 15 gallons but the refugium will be fed by a small Rio from the sump.

Doug

[andsoitgoes]

Okay - good. I've got the 10x return easy in my main tank, my MJ1200 + 301 will achieve that, and I'm thinking of adding another power head in there once I reorganize with the sump.

I'm actually planning on using the sump for skimming, heat, macro/fuge and as added water, so that helps - having the 50 or so GPH won't be too bad then, right?

[BCOrchidGuy]

In my opinion it wouldn't be bad. Maybe double that would be good too but I don't see a problem with that.

Doug

[mark]

I use a MJ1200 for my water changes from a rubbermaid container (plastic garbage can) to my sump which base sits 4 feet off the floor.

Using a 1/2" clear vinyl tubing takes probably 10-15 minutes to move 60L.