Ca reactor feed question

[kari]

Originally Posted by mark

I can easily block it off with my finger.

BTW, I asked the pressure rating from the manufacturer, and I wasn't much help to myself (DIY reactor ).

Haha, that means you have to build another one the same just to blow it up testing

It's easy to stop the flow in a 1/4" line because it has a x-section area of only 0.049 inch sq. Your reactor has a much greater surface area so total forces are greater while the pressure remains the same. Most likely you won't have any problems.

[mark]

Well feed from the main pump was too much. Though I cut a groove in both the upper lower flanges, I get a little weeping past the o-ring with the pump on.

Already returned the MJ400 so guess after X-mas be looking around for a mini-jet or the like.