![]() |
|
#1
|
|||||
|
|||||
![]() I have the same unit. Run your air pump through an air dryer and into the unit out to the skimmer... my skimmate production dropped a whole bunch too but the sludge that collects in the cup builds up way quicker, so I find that though I have to empty the collection vessel less frequently I have to clean the reaction chamber more...
__________________
135G Mixed Reef. Bullet 2, 25 gal refugium, 2 X250W MH + 4X 96W PC\'s, DIY Calcium Reactor, Coralife 1/6 HP Chiller, Phosban, Tunze, 2 closed loops & SQWD\'s, Seios, Coralife 4 stage RO/DI & a bunch of other expensive gadgets... I may never retire, but I'm gonnahavahelluvanaquarium! |
#2
|
|||||
|
|||||
![]() Ok let me get this right then.
On the ozone there is a in / out connector. and with that being said, starting from the air pump you should have air pushing in to the ozone on the inlet and a hose coming out of the ozone will be hooked up to the air dryer and then into the air hose for the skimmer right. i hope that is right oh ya my ozone i plugged it in to get a reading and my orp was 338 is that good and how much should i be startign out with on my tank.; I have a total of 235 gal 170 45 gal sump and a 20 gal refugium. what reading should i be going off of ? how high should i keep my controller at for a setting?
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. Last edited by Skimmerking; 08-21-2006 at 04:58 PM. |
#3
|
|||||
|
|||||
![]() Dry the air BEFORE the ozone unit... the dryer the air, the more efficient the ozone going to the skimmer is...
__________________
135G Mixed Reef. Bullet 2, 25 gal refugium, 2 X250W MH + 4X 96W PC\'s, DIY Calcium Reactor, Coralife 1/6 HP Chiller, Phosban, Tunze, 2 closed loops & SQWD\'s, Seios, Coralife 4 stage RO/DI & a bunch of other expensive gadgets... I may never retire, but I'm gonnahavahelluvanaquarium! |