|
|
|
#1
04-10-2006, 09:59 AM
|
|||||
|
|||||
Is this salt still OK?
I just went to mix up a batch of new water for a water change using my IO salt and I found that I hadn't put the lid on properly last time I used it. The salt is hard and I have to use a screwdriver to break it up. It seems to (completely) dissolve a little slower than I remember. I'm assuming some moisture has gotten in the bucket. (?) Will this salt still be OK or has some reaction taken place that's going to mess it up? The bucket is still 3/4 full.
__________________
Best Regards, Scott.  
|
|
#2
04-10-2006, 12:04 PM
|
|||||
|
|||||
|
It's fine. Probably didn't get wet. It has oxidized. (Reacted with oxygen in the air due to the lid not being closed).
Cheers  ,
__________________
Mark.
|
|
#3
04-10-2006, 12:21 PM
|
|||||
|
|||||
|
Quote:
Yup what he said 
__________________
Mark
|
|
#4
04-10-2006, 03:23 PM
|
|||||
|
|||||
|
The salt will also pick up moisture from the air which will cause it to clump. Still not a problem, just a nuisance.
__________________
I retired and got a fixed income but it's broke. Ed _______________________________________ 50 gallon FOWLR, 10 gallon sump. 130 gallon reef, 20 gallon sump, 10 gallon refugium. 10 gallon quarantine. 60 gallon winter tank for pond fish. 300 gallon pond with waterfall.
|
|
#6
04-11-2006, 12:11 PM
|
|||||
|
|||||
|
I am going to post the other side. some has hardened, so we might look at it as improper mixing (not that you did it but the same results type thing) where you add the water to the salt, it forms super saturation and falls out of solution forming different compounds. so what I am saying it that because some of the material has already had reactions because of the moisture it might be in a useless form (non soluble) so you might not get proper Ca, Alk ect. levels. also depending on your luck you might get different concentrations in your mixes.
Salt is cheap, buy a new bucket and cut your losses. Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#7
04-11-2006, 12:22 PM
|
|||||
|
|||||
|
Quote:
Cheers  ,
__________________
Mark.
|
|
#8
04-12-2006, 10:49 PM
|
|||||
|
|||||
|
I've made up over 20G of water and there is some white particulate that is not dissolving, or is dissolving verrrry slowly. The water is heated and has a PH in it. I'll have to test the water.
__________________
Best Regards, Scott.
|
Linear Mode
