Need help with wiring on workhorse

[StirCrazy]

Adam, because of the design of the workhorse ballast it will only run 1 VHO bulb, and it requires 3 of the 4 leads for this. you couls run 2 VHO ballasts at HO levels by putting 2 leads to each bulb. the only way around it would be if you could run 2 75watt VHO bulbs in series then run one other bulb off the left over wire.. but I would sugest running them at HO levels and getting another ballast for the PC's.

hope this helps

Steve

*warning advice is dispensed on a "to the best of my knowledge" basis... always verify information for your self before trying something that could be potentially dangerous*