NEED HELP WITH MP10

[rusty shackleford]

Try taking the unit off the tank , with the wet side off & far away

Plug it in then hold down mode button , it should start flashing white on the dial

If it does hold down mode & set at the same time

If it starts flashing white & yellow unplug the power cord from the drive box wait like 2 seconds and plug it back in

Good luck

[madkeenreefer]

I had same error red/green arrive on the mp10 for my salt mixing station last night.
Found some corrosion on the power conecition pin driver side.

Cleaned it up and good to go.
HTH

[davej]

Have you tried swapping the driver to see if its the driver that is the issue?
If that is your problem PM me I have a spare.

[Cujo#31]

Originally Posted by davej

Have you tried swapping the driver to see if its the driver that is the issue?
If that is your problem PM me I have a spare.

Yup.....Swapped drivers. Faulted driver worked perfect on other pump.