![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() Quote:
I'm using this for alk as well, I mixed and let it sit for a day before using, then stirred it again. I just started using this, prior I was using the liquid, but too costly with the issues I'm having atm. For mag and ca, I'm using Fauna Marin and no issues with it. What's your ratio for your mix Shelley? (just asking to make sure my math is correct)... |
#2
|
|||||
|
|||||
![]() Quote:
I'm "overdosing" according the instructions I think . . . but something in my system uses alk like crazy and I just can't keep it up. Plus, my salt seems to mix up low in alk: which compounds the issue. |
#3
|
|||||
|
|||||
![]() Hmmm. Can you not pre-mix it in a gallon jug of RO/DI and dose it with dosers? That's what I'd be looking at doing because of the volume and my tendency to forget
![]() |
#4
|
|||||
|
|||||
![]() I don't know if that can be done or not. I'm unaware of anything that could deteriorate or change if it was put into solution, but I don't know for sure.
|
#5
|
|||||
|
|||||
![]() I really like the SeaChem Reef Advantage Calcium and Reef Builder (or Reef Buffer), however they are quite pricey compared to other options. The trouble dissolving the alkalinity powder is typical since it really just doesn't dissolve easily. Some brands are a sniff better than others, but all in all it will take some mixing. I use a MaxiJet 1200 to mix for about an hour when I make up new solution.
I also really like the Fauna Marin "balling salts". I switched from FM to BRS in the last year, and when I'm done using up my BRS chems I'm going to switch back to the FM as I found I had better results. I can't say for sure it was the chems causing the difference in my corals, but I can say my tank looked better while using the FM balling salts than it does using BRS chems. You do not want to use epsom salts (magnesium sulfate) as primary magnesium supplement as your tank will get too high in sulfate. Magnesium should be supplied primarily by magnesium chloride with magnesium sulfate making up to 1 in 8-10 parts. Also, you should be pre-mixing in RO, not tank water since mixing in tank water would cause precipitation with the calcium in the cup of water. That precipitation under normal circumstances is chemically bound which essentially ties up a portion of that newly added alkalinity supplement (and the calcium it stole) as useless. If you add alkalinity supplements too fast to the water you will see a white cloudiness or even flaking which is the precipitation I'm referring to. Last edited by Myka; 08-04-2012 at 12:48 AM. |
#6
|
||||
|
||||
![]() I'm a cheapskate so I use Randy Holmes-Farley's DIY formulae.
http://reefkeeping.com/issues/2006-02/rhf/index.php |
#7
|
|||||
|
|||||
![]() Myka . . . I tried mixing with just RO last night, and I got the same flakes. I was hoping you were right about what was going on and that it was precipitation. I think I'm just not getting it mixed properly.
How much of this stuff can be mixed up into the top up water at once? Could one do a week's worth with no illeffects or degradation? |
#8
|
|||||
|
|||||
![]() Quote:
|
![]() |
Thread Tools | |
Display Modes | |
|
|