Arc fault circuit interupter

[outacontrol]

Originally Posted by troni

Must of been years since you've been on tools huh? Cause your talking like a office guy. Nobody is going to get a permit to move a plug.

Yes its the canadian electrical code but its a suggested code. Every province has its own legislatio

Man you are just full great information, are you sitting on the toilet when you write these replies? Cause I think some of your information and advise should be wiped up with some toilet paper and flushed.

The decision to pull a permit is a decision that everyone should make on their own from an educated stand point, you should not be advising people in a public forum that permits are not required.

When did you get your ticket? Does your boss know that you think the Canadian Electrical Code is just a suggested code? The CEC is the mandated legislated code, no if ands or buts about it! Every province has its own legislation - you must be refering the Alberta Standata, which is a document that amends and provides interpretation of the CEC.
As an electrician you can be fined, lose your ticket and even go to jail for breaking the code.

Please think twice before continuing with your miss-informed, and miss-leading information.

[troni]

This is tough to do:
Yes you are correct that is the proper way to do it. Thank you. Its tough keeping the proper mindset with a company like the one I work for.

[Avrbuster]

Originally Posted by troni

This is tough to do:
Yes you are correct that is the proper way to do it. Thank you. Its tough keeping the proper mindset with a company like the one I work for.

I have to say, it's nice to see someone admit they made a mistake on the internet. That is extremely rare. My hat is off to you troni!

On a personal side note, I know it's hard to stand up when you have tons of pressure to cut a few corners and your Bose (or Bosses) tell you to do it. But I would encourage you to voice your concerns. I'm no expert, but I believe in a court of law you are just as culpable as the company and could be open to litigation at a personal level. Don't think for one minute the company is going to stand behind you if sh*t hits the fan!

[kole]

Ok Now that we all know the law anybody have anything else to add to the original topic lol.

[wingedfish]

I've cut the arc fault plugs off of at least a dozen appliances (window a/c's) do to nuisance tripping. These are CSA mandated on some things for some reason but are just annoying in the field. Cannot imagine why anyone would want one on their tank.

I personally wil not put a gfci on my tank either. To each their own.

[Megalodon]

Sorry to bump an old thread, but I was doing some searching on arc fault interrupters here. My brother recommended I install one on my circuit breaker since I have a lot of things plugged in my condo and I'm paranoid about fire, especially with four cats that I probably wouldn't be able to all save in the event of a disaster.

That being said, my brother isn't a reefer and understandably isn't considering the damage to a tank being shut off for more than a day, and now that I've read about false trips, I'm starting to wonder if it's worth it.

Anyone have any more opinions or insight to share on this? I already have GFCI's up the ying-yang, but I do want the extra protection, not just for my tanks, but my computers and electrical equipment as well. Thanks.

[Doug]

In my place in Manitoba I had GFCI/AF breakers in the bedrooms, one of which was my office. I ran some of my tank on it and also had a dedicated 15a circuit installed on a GFIC. I was running halides then and they dont fire on arc fault.

My new place here has similar GFCI/AF breakers, again in bedrooms and one being my office. Thats all I,m running my tank on but I use LED lights now, so no problem and added protection.