|
|
|
|
|
#1
11-11-2009, 03:54 AM
|
|||||
|
|||||
EuroReef RS180 Mod - Question?
I have a EuroReef RS 180, it does work great, but I have seen mods where you cut the prongs of the needlewheel and then using a type of mesh, you create a different impeller that creates even smaller bubbles.
I am interested in this mod, but do not wish to destroy my impeller. Does anyone know where I could buy a modded impeller for my unit? or Is there a pump (suited for my unit) which comes with such a impeller? or with even more power Any advice is greatly appreciated, thanks.
__________________
 Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk Last edited by globaldesigns; 11-11-2009 at 05:23 AM. 
|
|
#2
11-11-2009, 05:22 AM
|
|||||
|
|||||
|
Euroreef was supposed to be coming out with an alloy meshwheel but I can't seem to find any info on it other than the initial announcement.
There were a few peoplein the US selling a meshwheel acrylic attachment for the impellers but that was a couple years ago, not sure if they're still selling them now.
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free.
|
Hybrid Mode
