Acrylic Router Bits - Canreef Aquatics Bulletin Board

		Canreef Aquatics Bulletin Board > General > DIY
Acrylic Router Bits

Thread Tools

Display Modes

06-27-2008, 05:29 AM

Chad

Member

Join Date: May 2003

Location: Surrey

Posts: 1,031

Acrylic Router Bits

What is everyone using for routing your edges when you DIY stuff? Where are you getting it to..

I bought a freud 3 fluted straight trimmer, it does an "ok" job, but it is not smooth enough to use Weldon #4.

Thanks..
Chad

__________________
Chad

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT. The time now is 05:26 PM.