Quote:
Originally Posted by LeanneP
The flow is 350 gph and I have the chiller set at 78 degrees and it should kick in at 2 degrees higher at 80 degrees
|
Ok, so less than 350 gph and I assume you mean your hysterisis is 2 degrees
We'll work on this setting later, after we get it running right
Quote:
Originally Posted by LeanneP
it still didn't seem to give me the correct temp
|
You may still need to set the Pd, or a similar code
If you hold the set button for, maybe, ten seconds or so, it will give you access to the initial temp and hysterisis settings
Mine reads Pd ( or ca, I had 2 chillers with different codes ) for temp calibration, and d for the hysterisis ( temp to run on and off ), not to be confused with the actual temp control setting
So,
Pd ( ca ) is temp calibration to your water
d is the hysterisis ( how much cooling variance you want )
xx degrees is your set temp
What readout do you get when you hold the set button for 10 or seconds ?
Mine starts with Pd, and if I press the set again, I get the d