|
|
|
#1
09-24-2010, 08:26 PM
|
||||
|
||||
custom acrylic work...where in town..(edmonton)
I recently aquired a Dymax IQ3 pico aquarium....
One of the key factors in keeping a pico reef successfully is keeping up with evaporation...to assist with this I would like to get a lid made for my tank. I am still working out exactly how I want it to fit but I am looking for info on good acrylic suppliers in Edmonton. tks Joel Last edited by jgoldsney; 09-24-2010 at 08:31 PM. 
|
|
#2
09-24-2010, 10:31 PM
|
|||||
|
|||||
|
With a some of pico's I seen guys just keep them in their display tank with netting over them and take them out to show them off. or they put it above their display and put a power head to 1/4 line with a valve and choke it down a a slow drip and if it over flows it overflows into the main tank.
__________________
Murray I reserve the right to hijack any thread I want to!! My carbon footprint is bigger than your carbon footprint !!!!
|
|
#3
09-24-2010, 11:43 PM
|
|||||
|
|||||
|
I don't know for sure if they do it but check out Mac's plastics.. there areound argile somewhere in there.. my buddys Dad used to own it and when I worked there in the 80's they did a lot of custom stuff, as well as skylights.
Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
Linear Mode
