|
#1
|
|||||
|
|||||
Thanks for the replies, both make sense.
I would have no concerns with the weight on my floor IF I could put the tank against one of the load bearing walls and perpendicular to the floor joists. I can put it perpendicular to the joists but the best spot I have is above the beam I mentioned in my first post. This beam spans roughly 20' and is made up of 4 - 2x10's (I think, it's drywalled). The tank wouldn't be directly over the beam as there is a partition wall directly over it but it would be in front of this wall. I guess it's worth mentioning that the tank would also be close to where this beam ties into a load bearing wall. If I could use a floor jack underneath I would but my garage is below. |
#2
|
||||
|
||||
A single 2x10 can support up to 1200lbs
__________________
220Gal Dining room build complete! no bucket or barrel water changes!!! |
#3
|
||||
|
||||
I lived in a wood frame apartment for 3 years on the fourth (top) floor and had 155 gallon tank with 30 gallon sump in my living room. This was concrete 1" skim coat over plywood floor and standard spacing 2x10 joists, maybe 8-12" spacing using a stud finder. BCAA insurance said no problem even after I asked them multiple times about a tank this size. I think you will be fine, I was nervous for months until I just accepted it and even forgot about it
__________________
155 bowfront restarted |
#4
|
|||||
|
|||||
Quote:
|