|
#1
|
|||||
|
|||||
In my tank, I just couldn't keep my Ca stable unless my Mg was 1400ish. Once I got my mag there, I could leave my Ca reactor set for months till I had to refill it. And I started seeing huge growth of SPS once my Ca hit 420.
Either way, start with getting your Mg stable where you want it. Then play with the other two. If you don't, you'll chase numbers till the cows come home. Sk8er on RC has a great write up on the relationships between the 3 |
#2
|
|||||
|
|||||
Quote:
And as for your other comments twisty, well you can't offer beers if you're halfway across the country Most of us that are talking to you are in BC, so good luck with the beers for trade stuff |
#3
|
||||
|
||||
LOL...
|
#4
|
||||
|
||||
Gave my LR and Acid bath this weekend.
Lot's of bubbles and FOAM! The rock looks good and ready to start the cycle. Any recommendations on how to start the cycle? Last edited by twisty; 03-02-2015 at 12:14 PM. |
#5
|
||||
|
||||
Also got a Vertex Deluxe RO/DI Unit...
Now i need to start mixing salt water |
#6
|
||||
|
||||
Return Pump
So I'm going to be purchasing a return pump. They guys @ J&L recommended the Sicce Syncra. Anybody use these pumps?
I'm having a hard time figuring out what one to use; re head loss. I plan on running both tanks with one return pump. The top tank is about 4.5' from the sump in height. I'll measure it tonight. I also want to create a manifold, so I can plumb media reactors on the same pump output. Any idea which pump I should run? Syncra 1.0 - 251 GPH <-- don't think this will be suitable. Syncra 2.0 - 568 GPH Syncra 3.0 - 714 GPH |
#7
|
||||
|
||||
sump design
I received my skimmer today
Now i'm trying to figure out what would be the best layout for my SUMP I haven't installed any baffles yet as I would like input. What do you guys think of this layout? Last edited by twisty; 03-03-2015 at 01:46 AM. |
#8
|
||||
|
||||
Here's the view from the font
|